LILYGO TTGO LoRa32 V2.1_1.6 Q211 - User Guide

Table of Contents
Flashing Meshtastic
Pairing to Android / iPhone (Initial Config)
Adding a GPS Module

    Flashing Meshtastic to a LoRa32 V2.1_1.6

    ***The LILYGO TTGO LoRa32 V2.1_1.6 Q211 comes pre-flashed with a PAX counter firmware.***

     
    • Plug the LilyGo LoRa32 into your computer using a USB cord. ***If your computer us not recognizing that a device is being plugged in you may need to install the serial drivers first found HERE.***
    • Select "T-LoRa V2.1-1.6" as the target device.
    firmware list
    • Select your preferred firmware version. We suggest using the newest Stable Beta.
    • Click flash
    • An info pop up will appear, scroll down and click continue.
    • Toggle the Full Erase and Install switch to the right and then click Erase Flash and Install.
    • Select the COM Port that your Meshtastic device is connected to. (If you are unsure which port it is on, simply unplug the device to see which one disappears.)
    • Wait for the device to finish flashing, then enjoy your newly flashed device.
     

    Pairing a LoRa32 V2.1_1.6 to Android / iPhone (Initial Config) 

    • Android:
    • iPhone:
     

    Adding a GPS Module to the LoRa32 V2.1_1.6